China (GuangDong)Foshan Winsco Metal Products Co., Ltd. Company News

The majority of uses for stainless steel coil tape require that the original appearance of the building be maintained over time. In determining the type of stainless steel coil tape to be selected, the main considerations are the aesthetic standards required, the corrosiveness of the atmosphere where it is located and the cleaning regime to be used. Other applications are increasingly just seeking structural integrity or impermeability. Examples include roofs and sidewalls of industrial buildings. In these applications, the cost of construction to the owner may be more important than aesthetics, and surfaces that are not very clean are fine. The use of 304 stainless steel works quite well in dry indoor environments. However, to maintain its appearance outdoors in rural and urban areas, it needs to be cleaned frequently. In heavily polluted industrial and coastal areas, the surface can be very dirty and even rusty. But to get the aesthetic effect in outdoor environment, it is necessary to use nickel-containing stainless steel coil tape. Therefore, 304 stainless steel is widely used for curtain walls, sidewalls, roofs and other architectural uses, but 316 stainless steel is used in highly aggressive industrial or marine atmospheres. There are several design guidelines that include both 304 and 316 stainless steel.

1.Pre-buried base plate Installation of pre-buried parts (after adding buried parts) railing pre-buried parts installation can only be used after adding buried parts practice, the practice is to use expansion bolts and steel plate to make the post connection, first put lines on the grass-roots level of civil construction to determine the location of the column fixing point, and then drill holes in the ground with a percussion drill, and then install expansion bolts, bolts to maintain sufficient length, after the bolt positioning, the bolt will be tightened at the same time the nut and screw welded between. prevent the nut from loosening with the steel plate. Handrail and wall surface connection also take the same method. 2.Placement When adding the buried parts construction, it may produce errors, so before the installation of the column, the line should be put again to determine the accuracy of the buried plate position and the welded column, if there is deviation, timely correction. 3.Welding column Installation of columns, welding columns, two people need to cooperate, one holding the steel pipe to keep it vertical, in the welding can not shake, the other person welding, to weld around, and should comply with the welding specifications. 4.Welding surface pipe, glass connectors Handrail and column before installation, put the line by drawing a long line, according to the tilt angle of the site and the roundness of the handrail used, and process the groove at its upper end. Then put the handrail directly into the groove of the column, and install the handrail from one end to the other in order of spot welding, with accurate docking of adjacent handrail installation and tight joints. After the adjacent steel pipe is docked, the seam is welded with stainless steel welding rod, and then set with plexiglass. 5.Polishing and polishing After all the welding is done, use the portable sander to flatten and sand the welded seam until it does not show the weld. 6.Installation of glass Plexiglass, glass and other railings, railings glass type, thickness should meet the design requirements, and should use the thickness of not less than 12mm tempered glass.